JVC HX-Z30 Service Manual page 20

3.3.8 Removing the side (R) assembly
(See Fig.18 ~ 22)
• Prior to performing the following procedure, remove the tray
assembly.
(1) Push and release the two tabs m of the gear cover through
the two notches inside the side (R) assembly. Remove the
gear cover outward.
(2) Remove the spring attached to part n of the hook on the
right side of the body.
(3) From top of the body, turn the 1 gear clockwise to move the
elevator cam rearward.Move the two slots o and joint p of
the elevator cam as shown in Fig.21 and remove the
elevator cam outward.
(4) Remove the three screws K and detach the side (R)
upward.
Caution:
When reattaching the side (R) assembly, make sure to fit the
shaft (part q) into the slot of the select lever.
K
K
Side (R)
assembly
K
Side (R) assembly
Sprihg
Gear cover
Elevator com
q
Fig.18
1 gear
n
Fig.19
Side (R) assembly
Fig.20
Spring
o
Fig.21
K
Side (R) assembly
Fig.22
m
n
Elevator cam
o
p
K
(No.MB043)1-23