Charging; Fuse; General Information/Specification; Bulb Removal - Toro 520XI Service Manual

ELECTRICAL
BATTERY (cont'd)

Charging

IMPORTANT: Always keep the battery fully
charged (1.260 specific gravity). This helps
prevent battery damage when the temperature
is below 32° F (0 °C).
1. Remove the battery from the chassis.
2. Check the electrolyte level.
3. Remove the filler caps and connect a 3 to 4
amp battery charger. Charge at a rate of 4
amps (12V) or less for 4 hours. Do not
overcharge the battery. Install the filler caps
after the battery is charged.
4. Install the battery in the chassis.

FUSE

General Information/Specification

The electrical system is protected by fuses. If a
fuse blows, check component/circuit for a
malfunction or short.
Fuse:
1. Main/Starter - 30 amp, blade type.
2. Alternator - 25 amp, blade type.
3. Dash, Interlock, and Cruise Control - 10
amp, blade type.
4. Headlights/Taillights - 10 amp, blade type.
6
NOTE: The number 2 fuse on diesel tractors is
for the starter and is 15 amp.
HEADLIGHTS

Bulb Removal

1. Disengage the PTO, set the parking brake,
turn the ignition key to OFF, and remove the
key.
2. Pull the wire connectors off both bulb holder
terminals.
3. Rotate the bulb holder 1/4 turn
counterclockwise and remove it from the
reflector.
4. Push and rotate the bulb counterclockwise
until it stops (approximately 1/4 turn) and
remove.
6-6
2.0144.070
2.7152.024
2.0109.030
5xi Series Tractor Service Manual