Bulb Removal; Electric Clutch Troubleshooting; General Information; Coil Resistance Measurement - Toro 520XI Service Manual

ELECTRICAL
TAILLIGHTS

Bulb Removal

1. Remove the taillight assembly from the
fender.
2. Rotate the bulb holder 1/4 turn
counterclockwise and remove it from the
housing.
3. Push and rotate the bulb counterclockwise
until it stops (approximately 1/4 turn).
Bulb Number:

ELECTRIC CLUTCH TROUBLESHOOTING

General Information

Equipment Needed: Volt/Ohm and Ampmeter
The following troubleshooting steps will help
you determine if the clutch has failed or is the
cause of the electrical problem.
6

Coil Resistance Measurement

Equipment: Volt/Ohmmeter
1. Disengage the PTO, set the parking brake,
turn the ignition key to OFF, and remove the
key.
2. Disconnect the clutch wire connector.
3. Set the volt/ohmmeter to check resistance
(ohms).
6-8
GE 194
2.0757.027
2.0144.006
2.0144.080
5xi Series Tractor Service Manual