Remote Notification Of Voice Messages - Mitel 1000 Owner's Manual

Dial 7 Go back ten seconds
Dial 8 Go forward ten seconds / Skip the time stamp
Dial 9 Forward the message to another extension
Dial 0 Return Call. Automatically make a call to the caller who left the
message (this feature is not applicable when mailbox is accessed remotely).
To monitor/pick-up callers as they speak to your Voice Mailbox
You can operate your voicemail in Voicemail Monitor Mode. In this mode,
when calls are forwarded to your Voice Mailbox and your extension is free, the
call is relayed over the speaker of your Featurephone. If you lift your handset
you can intercept the call in which case no message is left in the Voice
Mailbox.
Press the MESSAGE Key.
Select 'Voice Mail'.
Enter your extension number when prompted.
Enter your Voicemail Password, (1111 by default), followed by #.
Press the Scroll Down Key ( ) until 'Monitor' is displayed.
Select 'Monitor'.
Select 'Monitor on' or 'Monitor off'.
Press the Speakerphone Key to finish programming.
To change your Voicemail Password
By default, each extension is allocated the same Voicemail Password, (1111).
You can enter your own password, which can be up to eight digits long, as
follows:
Press the MESSAGE Key.
Select 'Voice Mail'.
Enter your extension number when prompted.
Enter your Voicemail Password, (1111 by default), followed by #.
Select 'Change password'.
Enter your new Voicemail Password, which can be up to eight digits long.
Press 'Confirm'.
Press the Hands-free Key to finish programming.
If you forget your Voicemail Password, you can check all
extension Voicemail Passwords from the Programming
Note
Extension.
To check all Voicemail Passwords
For configuration via the web interface, see page 104.
For configuration via the Featurephone interface, see page 174.

Remote Notification of Voice Messages

Extensions must be programmed to allow remote notification. See page 116
for programming from the Management Application and Page 172 for
programming from the programming Featurephone.
When a user turns remote notification on, a call will be made to the personal
or pager number programmed by the user to notify them that they have
received a new voice mail message.
65