Entering Dimensions; Entering Linear Dimensions; Entering Square/Cubic Dimensions - Calculated Industries 44080 Construction Master Pro Desktop v3.0 User Manual

ENTERING DIMENSIONS

Entering Linear Dimensions

When entering feet-inch-fraction values, enter dimensions from
largest to smallest — e.g., feet before inches, and inches before
fractions. Enter fractions by entering the numerator (top), pressing
/ (fraction bar key), and then the denominator (bottom).
Note: If a denominator is not entered, the fractional setting value is used.
Examples of Entering Linear Dimensions:
DIMENSION
Clear calculator
5 Feet 1-1/2 Inch
Clear calculator
5 Yards
Clear calculator
17.5 Meters

Entering Square/Cubic Dimensions

The Construction Master Pro lets you easily enter square and cubic
values. Simply press a dimensional unit key two times to label a
number as a square value, or three times to label a cubic value.
Note: If you pass the desired dimensional format, keep on pressing the dimensional
unit key until the desired result is displayed again.
Enter square and cubic dimensions in the following order:
(1) Enter numerical value (e.g., 1 0 0).
(2) Press desired unit key (e.g., f) to label value as "linear."
KEYSTROKE
o o
1 0 0 f
(3) Second press of unit key (e.g., f f) labels value as "square."
KEYSTROKE
o o
1 0 0 f f
(4) Third press of unit key (e.g., f f f) labels value as "cubic."
KEYSTROKE
o o
1 0 0 f f f
Note: Feet-Inches format cannot be used to enter square or cubic values.
KEYSTROKES
5 f 1 i 1 / 2
1 7 • 5 m
100
100
U ' G
SER S UIDE
o
o
5 y
o
DISPLAY
0.
100
FEET
DISPLAY
0.
SQ FEET
DISPLAY
0.
CU FEET
— 25