APPENDIX B — PREFERENCE SETTINGS
The Construction Master Pro calculators have Preference Settings
that allow you to customize or set desired dimensional formats and
calculations. The options vary per model.
If you replace your batteries or perform a Full Reset* (press O, hold
down x, and press o), your calculator will return to the following
settings (in addition to those listed on the previous page):
PREFERENCE
1) Fractional Resolution
2) Area Display Format
Note: To check the current Fractional Resolution, press ® / . Either "Std" (standard
fractional resolution) or "Cnst" (constant) will be displayed, along with the fractional
resolution).
OPTIONS
– *1/16 (displays fractional values to the
nearest 16th of an inch)
–
– 1/32
– 1/64
– 1/2
– 1/4
– 1/8
– *Standard (if units entered are the
same—e.g., feet x feet—the answer will
remain in this format (sq. ft), but if units
entered are different —e.g., inches x
feet—area answer will be displayed in
square feet)
– Square Feet (area answers always
displayed in sq. ft, regardless of unit
entry—e.g., inches x inches = sq. ft)
– Square Yards (area answers always
displayed in sq. yards—e.g., feet x feet
= sq. yds)
– Square Meters (area answers always
displayed in sq. meters—e.g., feet x feet
= sq. meters)
(Cont'd)
U
'
G
— 89
SER
S
UIDE