Camera; Motion - Digimerge DH200 SERIES Instruction Manual

CAMERA

Configure various camera settings,
such as brightness, contrast, title,
and covert.
Figure 13.0 Camera menu
To configure camera settings:
1. Under CAMERA SELECTION, press
select the camera.
2. Press to configure the following:
• COVERT: Select YES/NO. If YES, the camera
channel will be obscured from live viewing to
give the impression that no camera is
recording. Use this option if the display
monitor is in public view.
The Covert channel will use the
NOTE:
same background color as a
disconnected camera. To change the
background color, see "DISPLAY" on
page 22.
• BRIGHTNESS, CONTRAST, COLOR: Adjust
from 0~100.
• TITLE: Use the alpha-numeric buttons on the
remote control to enter a name/title for the
camera. Press
right. If you make a mistake, press CANCEL/
ESC to return to the Main Menu and start
again.
• PTZ MODEL: Select the model of your
connected PTZ camera (not included).
• PTZ ID: Enter your PTZ ID (PTZ ID should
match the camera channel to which you have
connected the PTZ camera)
3. Repeat for other camera connected to the
system.
4. Press to save your settings. Press
ENTER
to close remaining menu
CANCEL/ESC
windows.
to
to move the cursor left/

MOTION

Configure the motion grid and
motion sensitivity for specific
channels.
If motion detection is applied to a
NOTE:
camera, the system will record from that
camera when motion is detected.
only
Figure 14.0 Motion menu
To configure motion settings:
1. Under RECORD TIME, adjust the time from
10~300 seconds.
The set recording time is
NOTE:
applicable to all channels.
2. Press to select CAMERA SELECTION
and press to select the camera.
3. Press to select SENSITIVITY, and adjust
from 1~20. The higher the number, the
greater the sensitivity.
4. Press to select MOTION GRID. Press
to move the cursor to the Motion Grid.
+
5. Press to select blocks on
the grid. A green motion icon
appears on the grid.
• Press
block on the grid
Using the Main Menu
to select a
+
23