Basic Setup; Connect The Cameras; Connect A Monitor; Connect The Mouse (Usb Or Ps/2) - Digimerge DH200 SERIES Instruction Manual

BASIC SETUP

1. Connect the cameras

a. Connect BNC cameras to the BNC ports on the
rear panel (4/8-channel models).
OR
a. 16-CHANNEL MODELS ONLY: Connect the single
end of the octopus cable to the VIDEO IN1-16 port
(see figure 1.1).
b. Connect BNC cameras to the octopus cable.

2. Connect a monitor

a. Connect a VGA cable (not included) from the VGA
port on the rear panel to the VGA port on your
monitor.
OR
a. Connect a BNC terminated cable from one of the
Video OUT ports to a TV or CCTV monitor.

3. Connect the mouse (USB or PS/2)

a. Connect the mouse to the USB mouse port on the
rear panel.
If using a PS/2 mouse, a USB adapter will
NOTE:
be required (not included).

4. Connect the Ethernet cable

a. Connect an Ethernet cable to the LAN port on the
rear panel of system; connect the other end of the
Ethernet cable to an empty LAN port on your
router or switch (not included).

5. Connect the power cable

a. Connect the power supply to the DC 12V port on
the rear panel of the system; connect the power
cable to an outlet, power strip, or surge protector.
2
Figure 1.0 Connect BNC cameras to the system
Figure 1.1 Octopus cable port (16-channel only)
Figure 1.2 Connect to a VGA or CCTV monitor, or a TV
Figure 1.3 Connect an Ethernet cable and mouse
Figure 1.4 Connect the power cable