Rear Panel - Digimerge DH200 SERIES Instruction Manual

REAR PANEL

1
Figure 1.7 Rear panel (8-channel model shown)
1. CAMERA IN: Camera input ports for BNC cameras (4/8-channel);
VIDEO IN 1-16
: Port for octopus cable (16-channel models
2. VIDEO OUT: Video output (BNC) to connect the system to a secondary monitor or DVR.
3. AUDIO IN: One 3.5" RCA port (mono) for recording audio from an audio capable camera (not included).
4. VGA: VGA port to connect the system to a VGA monitor.
5. LAN: Connect an Ethernet cable to connect the system to a router or switch (not included).
6. MOUSE: USB port to connect a USB or PS/2 mouse (PS/2 mouse requires USB adapter).
NOTE: Do not connect a USB flash drive to the "Mouse" port. The USB port on the front panel has been
specifically designed for high-speed data transfer to a USB flash drive.
7. ALARM IN: Alarm block to connect external alarm or motion devices (not included).
8. SPOT OUT: Video output to connect the system to an external monitor (not included). Spot Out mode
only displays channels switching in an automatic sequence.
9. AUDIO OUT: One 3.5" RCA port (mono) for audio output.
10. RS422 / 485 / OUT: Connection block for an RS422/485 PTZ
camera (not included).
NOTE: The RS232 ports are for development purposes only.
A PTZ camera cannot be controlled from these ports.
11. DC 12V: Port for 12V DC 3A power supply (included).
12. Exhaust fan: Do not block. Keep clear to allow for proper
ventilation.
3
2 4
5
8 9
6 7
10 11
only
—see figure 1.8)
Figure 1.8 Octopus cable VIDEO IN (16-channel only)
12
5