Table of Contents
Advertisement
DANGER
To prevent fire or explosion hazard when testing for a leak:
1.
Always perform the "leak test" on page 14 before lighting the grill and each time the cylinder is connected for use.
2.
Do not smoke or allow other sources of ignition in the area while conducting a leak test.
3.
Conduct the leak test outdoors in a well-ventilated area.
4.
Do not use matches, lighters or a flame to check for leaks.
5.
Do not use grill until all leaks have been stopped. If you are unable to stop a leak, disconnect the propane supply, call for gas
appliance service or your local propane gas supplier.
1.
Make 2-3 oz. of leak solution by mixing one part liquid dishwashing soap with three parts water.
2.
Make sure control knobs are in the "OFF" position.
3.
Spray some solution on the tank valve up to the regulator connection.
(See diagram to right.)
4.
Inspect the solution at the connections for bubbles. If no bubbles appear,
the connection is secure.
5.
If bubbles appear, you have a leak. Go to step 6.
6.
Disconnect the regulator from the tank and reconnect. Make sure the connection is secured.
7.
Retest with solution.
8.
If you continue to see bubbles, replace the cylinder.
Danger: Failure to open lid while igniting the grill's burners or not waiting five minutes to allow gas to clear if the grill does not
light may result in an explosion, which could cause serious bodily injury or death.
WARNING: Never stand with your head directly over the grill when preparing to light the main burners, to prevent possible
bodily injury.
Main Burner.
1.
Read and follow all warnings and instructions in owner's manual before lighting.
2.
Open lid before lighting burner.
WARNING: Attempting to light the burner with the lid closed may cause an explosion. Make` sure there are no obstructions
of airflow to the gas unit. Spiders and insects can nest and clog the burner/venturi tube at the orifice. A clogged burner tube
can lead to a fire beneath the appliance.
3.
Make sure all control knobs are in OFF position.
4.
Open cylinder/ main gas valve.
5.
Push and turn the desired IGNITION BURNER control knob to the "HIGH" position.
6.
Press the igniter button, thus the burner should be lit.
7.
If the burner does not light, press the igniter 2 to 3 times.
8.
If the burner still does not light in 5 seconds, turn the control knob to the "OFF" position, wait 5 minutes and repeat the lighting
procedure.
9.
To light other burners, push and turn control knobs to HIGH in sequence from most close with ignition burner one.
10. To turn off, turn control knobs clockwise until it locks in OFF position.
NOTE: Turn off LP supply at cylinder when appliance is not in use.
Using the Lighting Stick to Light the Main Burners
1.
Insert a match into the end of the lighting stick. Light the match.
2.
Once lit, place the flame through the hole on grill body to reach the burner ports.
(See diagram to right.)
3.
Press the valve knob and rotate it counterclockwise to the ''HIGH'' position. The
burner should light immediately. If more than one burner is desired, repeat the
same procedure for the adjacent burner and continue in sequence until all
desired burners are lit.
4.
Adjust burners to the desired cooking temperature.
GSF3016A
Owner's Manual
Checking for Leaks
.
Lighting Your Grill
14
Advertisement
Table of Contents
