Covers Removal For Servicing; Components Removal For Service; Parts Replacement; Adjustments And Replacement Parts - Heat & Glo 6TRSI-AUD Owner's Manual

E. Covers Removal For Servicing
Control Compartment Access Door
• Lift the lower door up and out to access the gas controls.
Trim Door and Glass Door
• Lift the front trim door up and out away from the appliance
side surrounds. Replace the door when servicing is
complete.
• Noting carefully how the brackets fi t on the glass, release
the two spring latches at the top and two at the bottom
of the glass door. Carefully lift the glass up and out away
from the appliance. See Figure 9.15.
LATCHES
(BOTH BOTTOM
AND TOP)
GLASS
ASSEMBLY
Figure 9.15 Fixed Glass Assembly
F. Components Removal For Service
Burner Assembly Removal
• Carefully remove logs.
• Remove 3 screws that attach the grate to the base pan
and remove grate.
• Remove 2 pilot cover screws. See Figure 9.16.
• Remove 2 pilot bracket retaining screws. See Figure
9.17.
• Remove base pan.
• Remove 2 burner screws located at both ends of burner.
• Slide burner to left and remove.
PILOT COVER
SCREWS
BASE PAN
Figure 9.16
Heat & Glo • 6TRSI-AUD, 6TRSILP-AUD • 2078-980 Rev. Q • 2/14
PILOT BRACKET RETAINING
SCREWS
Figure 9.17
NOTICE: All screws which were removed must be replaced.
Pilot Assembly/Ignition System
• Follow the steps in the previous "Burner Assembly Removal"
section.
• Disconnect the gas supply tube from the outlet side of
valve.
• Disconnect the orange ignitor wire (I) and white sensor
wire (S) from module.
• Unscrew the pilot assembly from the pilot bracket and re-
move. Remove pilot assembly along with silicone sealant
grommet.
G. Parts Replacement
Fan
• Unplug the fan from the AUX300CE and slide the fan out
the front of the lower controls compartment.
• Fan can be operated at 3 speed levels using RC300AU
remote and AUX300CE. Refer to RC300AU section.
• The fan will automatically turn on after 3 minutes and will
stop 12 minutes after unit has been turned off.
Glass Panel
• To replace the glass door, place the bottom edge into the
lower holders, push glass against unit and secure the two
spring latches at the top and bottom.
H. Adjustments And Replacement Parts
Adjustments and replacement parts for this appliance should
only be done by a qualifi ed service person. A wiring diagram
for the appliance is shown in Section 12. A service parts list
is shown in Section 16 of this manual.
I. Install Trim and/or Surround
• Install optional trim kits and/or surrounds using the
instructions included with the accessory.
• Use non-combustible materials to cover the gap between
the sheet rock and the appliance (when applicable to the
model).
J. Air Shutter Setting
Natural Gas
6TRSI-AUD 12.5 mm
6TRSILP-AUD N/A
Propane Butane
N/A N/A
Full Open Full Open
43