Heat & Glo 6TRSI-AUD Owner's Manual page 2

MODELS: 6TRSI-AUD, 6TRSILP-AUD
ARE SAI GLOBAL APPROVED FOR
NATURAL GAS, PROPANE OR BUTANE
AS A BALANCED FLUE HEATER.
Refer to the appliance data plates for gas
consumptions and pressures.
Installation of this appliance should only
be carried out by an authorized person
in accordance with the manufacturer's
instructions. Appliance is to be installed
in full compliance with the National Gas
Installation Standard AS5601, the manu-
facturer's instructions, and any local au-
thorities' requirements for gas, electrical
and building regulations.
This appliance and its components are
tested and safe when installed in accor-
dance with this Installation Manual. Report
to your dealer any parts damaged in ship-
ment, specifi cally check glass condition.
The gas logs and fl ue system components
are in separate packages. Read all in-
structions before starting installation and
follow these instructions carefully during
Heat & Glo, a brand of Hearth & Home Technologies
7571 215 th Street West, Lakeville, MN 55044
Copyright 2013 • Printed in U.S.A.
2
PLEASE READ THIS MANUAL BEFORE INSTALLING
AND USING THIS APPLIANCE.
It is the responsibility of the professionals involved with the service
and installation of the appliance to test the operation of the appliance
before leaving the installation site.
IMPORTANT: Read all instructions carefully before starting installation.
Failure to follow these installation instructions may result in a possible fi re
hazard and will void the warranty. Save this manual for future reference.
Heat & Glo • 6TRSI-AUD, 6TRSILP-AUD • 2078-980 Rev. Q • 2/14
installation to ensure maximum benefi t and
safety. Failure to follow them will void your
warranty and may present a fi re hazard.
The Heat & Glo, a brand of Hearth & Home
Technologies warranty will be voided by,
and Heat & Glo, a brand of Hearth & Home
Technologies disclaims any responsibility
for the following actions:
• Installation of any damaged heater or fl ue
system component
• Modifi cation of the heater or balanced
fl ue system installation other than as
instructed by Heat & Glo, a brand of
Hearth & Home Technologies.
• Improper positioning of the gas logs or
the glass door
• Installation and/or use of any component
part not manufactured or approved by
Heat & Glo, brand of Hearth & Home
Technologies, not withstanding any in-
dependent testing laboratory or other
party approval of such component part
or accessory.