Touchpad Button Board - HP Pavilion G6 Maintenance And Service Manual

TouchPad button board

Description
TouchPad button board (includes cable)
Before removing the TouchPad button board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the service door (see
6. Remove the optical drive (see
7. Remove the hard drive (see
8. Remove the keyboard (see
9. Remove the top cover (see
Remove the TouchPad button board and cable:
1. Turn the top cover upside down, with the front toward you.
2. Release the ZIF connector to which the TouchPad button board cable is connected, and then
disconnect the TouchPad button board cable (1) from the back of the TouchPad.
3. Remove the PM 2.5 x 2.5 screw (2) that secures the TouchPad button board cable to the top
cover.
4. Lift the front edge of the TouchPad button board (3) until it is released from the clips built into
the top cover.
54 Chapter 4 Removal and replacement procedures
Battery on page 34).
Service door on page
Optical drive on page
Hard drive on page
Keyboard on page 45).
Top cover on page 48).
35).
36).
38)
Spare part number
683548-001