License Plate Lamp - Chevrolet Silverado Classic 2007 Owner's Manual

Taillamps (Chassis Cab Models)
To replace one of these bulbs, do the following:
1. Peel the rubber seal away from the lens.
2. Lift the lens off the lamp assembly.
3. Pull the old bulb straight out from the socket.
4. Install a new bulb into the socket and
press it in until it is tight.
5. Reinstall the lens and the lens seal.
542
A. Turn Signal Lamp
B. Taillamp/Stoplamp
C. Back-up Lamp

License Plate Lamp

To replace one of these bulbs, do the following:
1. Reach under the rear bumper for the
bulb socket.
2. Turn the bulb socket counterclockwise and
pull the bulb socket out of the connector.
3. Pull the old bulb from the bulb socket, keeping
the bulb straight as you pull it out.
4. Install the new bulb.
5. Reverse Steps 1 through 3 to reinstall the
bulb socket.