Chevrolet Silverado Classic 2007 Owner's Manual page 82

7. If your child restraint manufacturer
recommends using a top tether, and the
position you are using has a top tether anchor,
attach and tighten the top tether to the top
tether anchor. Refer to the instructions
that came with the child restraint and to Lower
Anchors and Tethers for Children (LATCH)
on page 56.
8. Push and pull the child restraint in different
directions to be sure it is secure.
9. If your vehicle has a passenger sensing
system and the airbag is off, the off indicator in
the inside rearview mirror will be lit and stay
lit when the key is turned to RUN or START.
If a child restraint has been installed and the
on indicator is lit, turn the vehicle off. Remove the
child restraint from the vehicle and reinstall the
child restraint.
82
If, after reinstalling the child restraint and restarting
the vehicle, the on indicator is still lit, check to
make sure that the vehicle's seatback is not
pressing the child restraint into the seat cushion.
If this happens, slightly recline the vehicle's
seatback and adjust the seat cushion if possible.
Also make sure the child restraint is not trapped
under the vehicle head restraint. If this happens,
adjust the head restraint.
If the on indicator is still lit, secure the child in
the child restraint in a rear seat position in
the vehicle if one is available and check with
your dealer.
To remove the child restraint, if the top tether is
attached to the top tether anchor, disconnect
it. Unbuckle the vehicle's safety belt and let it
go back all the way. The safety belt will move
freely again and be ready to work for an adult
or larger child passenger.