Chevrolet Silverado Classic 2007 Owner's Manual page 336

The RSE system will always transmit the audio
signal by infrared to the wireless headphones,
if there is audio available. See "Headphones"
previously for more information.
The RSE system is capable of outputting audio
to the vehicle speakers by using the radio.
The RSE system may be selected as an audio
source on the radio if the RSE system power is on.
Once the RSE system is selected as an audio
source on the radio, adjust the speaker volume
on the radio, if necessary. If the RSE system
power is not on, the RSE system will not be an
available source on the radio. Refer to the
radio information for the radio that your vehicle
has for more information.
The RSE system is capable of outputting audio
to the wired headphone jacks on the rear
seat audio system (if equipped). The RSE system
may be selected as an audio source on the
rear seat audio system if the RSE system
power is on. Refer to Rear Seat Audio (RSA)
on page 346 for more information.
336
Video Screen
The video screen is located in the overhead
console. To use the video screen, push forward
on the release latch and the screen will fold down.
Adjust the screen's position as desired. When
the video screen is not in use, push it up into its
latched position.
The DVD player and display will continue to
operate when the screen is in the up or the
down position. The video screen contains the
transmitters for the wireless headphones and
the remote control. If the screen is in the closed
position, the signals will not be available for
the operation of the headphones or the remote
control.
Notice: Avoid directly touching the video
screen, as damage may occur. See "Cleaning
the Video Screen" later in this section for
more information.