Setting The Remote Transmitter And Receiver - Hunter 41922-01 Installation And Operation Manual

You must now set the jumpers in the remote transmitter and receiver
so that they match.
4-1. Change the position of the jumpers in the transmitter and the
receiver. Be sure the position of the jumper in the transmitter
matches the position of the jumper in the receiver. If they don't
match, the controller will not function. For instructions on how to
set the jumpers, read the box below.
4-2. Install the included 12-volt battery into the transmitter.
Setting Jumpers
When two or more fans are located near each other, you may desire to
have the receiver/transmitter for each fan set to a diff erent code, so that
the operation of one fan does not aff ect the operation of the other fans.
In the transmitter you can access the jumpers from the battery
compartment.  e jumpers are very small. You can move them most
easily using a small pair of pliers or tweezers. IMPORTANT! Before
you change a jumper, make sure the battery is not connected to the
transmitter.
CAUTION:  e remote control device complies with part 15 of the FCC rules.
Changes or modifi cations not expressly approved by Hunter Fan Company could void
your authority to operate this equipment.
Operation is subject to the following two conditions:
1.  is device may not cause harmful interference.
2.  is device must accept any interference received, including interference that may
cause undesired operation.
Note: Use with a fan that incorporates an air gap switch (normal on-off wall switch).
WARNING: Maximum fan load is 1 Amp; maximum lamp is 100 Watts. Do not use
any speed control with this product.
41922-01 • 02/26/07
4 • Setting the Remote Transmitter and Receiver
Example Jumpers Settings
Receiver 1 Receiver 2
4 3 2 1 4 3 2 1
4 3 2 1 4 3 2 1
Transmitter 1 Transmitter 2
4 3 2 1 4 3 2 1
4 3 2 1 4 3 2 1
4 = off 4 = off
3 = on 3 = on
4 = off 4 = off
2 = on 2 = off
3 = on 3 = on
1 = on 1 = on
2 = on 2 = off
1 = on 1 = on
Hunter Fan Company
7