Setting The Remote Transmitter And Receiver - Hunter 25745 Owner's Manual And Installation Manual

7 • Setting the Remote Transmitter and Receiver
You must now set the jumpers in the remote transmitter and receiver
so that they match.
7-1. Change the position of the jumpers in the transmitter and the
receiver. The receiver is located inside the lightkit. Be sure the
position of the jumper in the transmitter matches the position of
the jumper in the receiver. If they don't match, the controller will
not function.
7-2. Install the included 12-volt battery into the transmitter.
Setting Jumpers
When two or more fans are located near each other, you may desire to
have the receiver/transmitter for each fan set to a different code, so that
the operation of one fan does not affect the operation of the other fans.
In the transmitter you can access the jumpers from the battery
compartment. The jumpers are very small. You can move them most
easily using a small pair of pliers or tweezers. IMPORTANT! Before
you change a jumper, make sure the battery is not connected to the
transmitter.
CAUTION: The remote control device complies with part 15 of the FCC rules.
Changes or modifications not expressly approved by Hunter Fan Company could void
your authority to operate this equipment.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may
cause undesired operation.
Note: Use with a fan that incorporates an air gap switch (normal on-off wall switch).
WARNING: Maximum fan load is 1 Amp; maximum lamp is 100 Watts. Do not use
any speed control with this product.
10
42419-01 • 11/24/08 • Hunter Fan Company
Example Jumpers Settings
Receiver 1 Receiver 2
4 3 2 1 4 3 2 1
4 3 2 1 4 3 2 1
Transmitter 1 Transmitter 2
4 3 2 1 4 3 2 1
4 3 2 1 4 3 2 1
4 = off (apagado) 4 = off (apagado)
3 = on (encendido) 3 = on (encendido)
4 = off (apagado) 4 = off (apagado)
2 =
2 = on (encendido) off (apagado)
3 =
3 = on (encendido) on (encendido)
1 =
1 = on (encendido) on (encendido)
2 = on (encendido) 2 = off (apagado)
1 =
1 = on (encendido) on (encendido)