Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Hunter 41844-01
Summary of Contents for Hunter 41844-01
- Page 1 1 1 1 1 1 © 2002 Hunter Fan Company 41844-01 12/20/2002...
-
Page 2: Getting Ready
To install a ceiling fan, be sure you can do the following: • • • • If you need help installing the fan, your Hunter fan dealer can di- rect you to a licensed installer or electrician. gathering the tools You will need the following tools for installing the fan: •... -
Page 3: Preparing The Fan Site
If your existing fan site is suitable, go to the in in in in ins s s s s t t t t t a a a a a llin p p p p p l l l l l a a a a a t t t t t e e e e e section and begin installing your new Hunter fan. -
Page 4: Installing The Ceiling Plate
Thread the fan supply line through the outlet box so that the fan supply line extends at least 6" beyond the box as shown in Figure 7. Attach the fan supply line to the outlet box with an approved connector, available at any hardware store or electrical supply house. -
Page 5: Hanging The Fan
© 2002 Hunter Fan Company hanging the fan Raise the fan and place the hook through the loop on the ceil- o us s s s s e e e e e ing plate as shown in Figure 12. Use the note and arrow en- graved in the ceiling plate to assist in determining the direc- tion to assemble. -
Page 6: Installing The Canopy
Rotate the fan 180º clockwise from the initial position when hanging the fan. The arrows on the hanger ball and on the ceiling plate should be pointing in the same direction and should be pointing towards the tab hole on the canopy. Refer to Figure 14. -
Page 7: Assembling The Blades
Remove the blade mounting screws and rubber shipping bumpers from the motor. For each blade, insert one blade mounting screw through the blade iron as shown in Figure 21, and attach lightly to the fan. Insert the second blade mounting screw, then securely tighten both mounting screws. -
Page 8: Operating Your Ceiling Fan
To change the direction of air flow, turn the fan off and let it come to a complete stop. Slide the reversing switch on the fan to the opposite position as shown in Figure 26. Restart fan. -
Page 9: Troubleshooting
Wood finish blades should be cleaned with a furniture polishing cloth. Occasionally, a light coat of furniture polish may be applied for added protection and beauty. Painted and high-gloss blades may be cleaned in the same manner as the fan finish. troubleshooting Problem: Nothing happens; fan does not move.