Table of Contents
Advertisement
All wiring must be in accordance with national and local electrical
codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a
qualified electrician.
6-1. Make sure the power is still off.
6-2. To connect the wires, hold the bare metal leads together and place
a wire nut over them, then twist clockwise until tight. For all these
connections use the wire nuts provided.
CAUTION: Be sure no bare wire or wire strands are visible after
making connections.
6-3. Using a large wire nut, connect the ground wire from the ceiling to
the green ground wire from the ceiling plate and the green ground
wire from the downrod.
6-4. Using the large wire nuts, connect the white wire and the black
wire from the ceiling as follows:
• e white (common) power wire from the ceiling to the white
wire from the receiver (marked on red tag "NEUTRAL IN")
• e black power wire from the ceiling to the black wire from
the receiver (marked on red tag "LIVE IN")
6-5. Using the small wire nuts, connect the wires from the fan as
follows:
• e black/white wire from the fan to the red wire from the
receiver (marked on white tag "LIGHT OUT")
• e black wire from the fan to the black wire from the receiver
(marked on white tag "FAN OUT")
• e white wire from the fan to the white wire from the receiver
(marked on white tag "COMMON OUT")
6-6. Check each connection to make sure no bare wire or wire strands
are visible. Push all wires and wire nuts, except for the white
antenna wire from the receiver, back through the ceiling plate into
the outlet box.
6-7. Position the receiver in the canopy so that the antenna is close to
the edge of the ceiling plate for clear reception.
41895-01 • 10/14/05
6 • Wiring the Fan
Receiver
Steps 6-3 – 6-7
Large Wire Nut
Small Wire Nut
Hunter Fan Company
Antenna
9
Advertisement
Table of Contents
