Table of Contents
Advertisement
8
installing the switch housing
attaching the upper switch housing
1.
Partially install two #6-32 x 3/8" housing assembly screws into
the switch housing mounting plate as shown in Figure 22.
2.
Feed the upper plug connector through the center opening of
the upper switch housing. See Figure 22.
Switch Housing
Mounting Plate
Upper Switch
Housing
Figure 22 - Attaching the upper
switch housing to the mounting plate
3.
Align the keyhole slots in the upper switch housing with the
housing assembly screws installed previously.
4.
Turn the upper switch housing counterclockwise until the
housing assembly screws are firmly situated in the narrow end
of the keyhole slots as shown in Figure 23. Install the one re-
maining #6-32 x 3/8" housing assembly screw into the third
hole in the upper switch housing. Tighten all three screws
firmly.
Figure 23 - Mounting the upper switch housing
CAUTION: Make sure the upper switch housing is se-
curely attached to the switch housing mounting plate. Fail-
ure to properly attach and tighten all three housing assem-
bly screws could result in the switch housing and light fix-
ture falling.
attaching the lower switch housing
1.
Connect the upper plug connector from the motor to the lower
plug connector in the lower switch housing assembly. See Fig-
ure 24.
NOTE: Both plug connectors are polarized and will only fit
together one way. Make sure that both connectors are prop-
erly aligned before connecting them together. Incorrect con-
nection could cause improper operation and damage to the
product.
41892-01 03/17/2005
41892-01_Rev 03.17.05.pmd
8
2.
Housing
Assembly
Screw
Upper Plug
Connector
installing the glass shades and bulbs
Refer to Figures 25 and 26.
1.
2.
3.
Lower Plug
Connector
Housing
Assembly
Screw
Figure 24 - Connecting the plug connectors
Place the lower switch housing assembly over the upper switch
housing. Align the side screw holes in the upper and lower
switch housings. Attach the lower switch housing to the up-
per switch housing with three #6-32 x 3/8" housing assembly
screws. See Figure 24.
Place globe over threaded lampholder in cup.
Install and hand tighten threaded locking ring on lampholder.
NOTE: As shown in Figure 1b, line up the beginning of the first
thread on the lamp holder and notch on the locking ring to avoid
cross threading the ring. If ring becomes hard to turn, turn
ring counter-clockwise to loosen. Do not force the ring on.
Install A-15 Max 60 Watt bulbs.
Globe
Figure 25 - Multifixtures
Notch in Ring
Figure 26 - Locking Ring Assembly
3/18/05, 8:44 PM
Upper Switch
Housing
Upper Plug
Connector
Lower
Switch
Housing
Cup
Threaded
Lamp Holder
Threaded
Locking Ring
Beginning of
First Thread
Threaded
Locking Ring
© 2005 Hunter Fan Company
Advertisement
Table of Contents
