Assembling The Fan - Hunter 41892 Installating And Operation Manual

Hunter fan ceiling fan owner's manual

Hide thumbs

Table Of Contents

Table of Contents

Align the slotted holes (refer to Figure 9) in the ceiling plate

with the pilot holes in the wood support structure. Note: The

isolation pads should be flush against the ceiling.

For Angled Ceilings: Be sure to orient the ceiling plate so that

the arrows on the ceiling plate are pointing towards the ceiling

peak. Refer to Figure 9.

Arrows for Orienting

on Angled Ceiling

Figure 9 - Locating the slotted holes to use

Place a flat washer on each of the two 3" screws and pass the

screws through the slotted holes in the ceiling plate as shown

in Figure 10.

Tighten the screws into the 9/64" pilot holes; do not use lubri-

cants on the screws. Do not overtighten.

Ceiling Plate

Flat Washer

Figure 10 - Installing the ceiling plate

assembling the blade irons

Use the styrofoam packaging to support the motor housing

while assembling the blade irons.

Place the blade bracket through the hole in the side of the

lower motor housing. Refer to Figure 11.

Install the two blade bracket screws as shown in Figure 11.

Blade Bracket

Lower Motor

Housing

Figure 11 - Installing the blade brackets

41892-01_Rev 03.17.05.pmd

Slots

Ceiling Joist

2 x 4 Brace

Ceiling

Outlet Box

3" Wood Screw

Blade

Bracket

Screws

Place the upper motor housing over the adapter as shown in

Figure 12. Align the holes in the upper motor housing with

the holes in the adapter.

Partially install the three motor housing screws.

NOTE: Make sure the gap between the upper and lower mo-

tor housing is even all the way around.

Securely tighten all three motor housing screws. Refer to Fig-

ure 12.

Adapter

Upper Motor

Housing

Figure 12 - Assembling the upper motor housing