Section 4: Troubleshooting For Homeowner - Quadra-Fire Edge60 Owner's Manual

EDGE 60 Pellet Fireplace
4
Troubleshooting for Homeowner
A. Frequently Asked Questions
ISSUES
1. Metallic noise
. Ash buildup on glass
. Glass has turned dirty
4. Fire has tall flames with black tails and is lazy
5. Excessive smokey start-up
6. Large flame at start-up
7. Mechanical Noise
NOTICE:
Odors and vapors are released during initial operation due to the curing of high tem-
perature paint. Open windows for air circulation. Ordors may be irritating to sensitive individuals.
Page 0
SOLUTIONS
1. Noise is caused by metal expanding and contracting as it heats
up and cools down, similar to the sound produced by a furnace or
heating duct. This noise does not affect the operation or longevity
of your appliance.
. This is normal. Clean the glass.
. Excessive build up of ash. The lower burn settings will produce
more ash, the higher burn settings produce less. The more it burns
on low the more frequent cleaning of the glass is required.
4. The flame height adjustment needs to be reduced or the firepot
needs cleaning. Heat exchanger & combustion blower needs
cleaning.
5. Either the firepot is dirty or there is too much fuel at start-up and not
enough air.
6. This is normal. Flame will settle down once the fire is established.
Some smoke is normal.
7. The floor of the firepot in the auto-clean system may make some
noise as it scrapes the ash into the ash pan.
7051-158
R
April 9, 2009