Front Installation Instruction - Quadra-Fire Edge60 Owner's Manual

EDGE 60 Pellet Fireplace
B. Front - Installation
Included in Kit: Front, mounting frame, masonry spacer, fasteners
and glove
Tools Required: Phillips Head screwdriver
CAUTION! BURN HAZARD. Allow the front to cool before touch-
ing. Do NOT touch without wearing protective glove.
Door Stop - Disassemble & Re-install
1. Using a Phillips Head screwdriver remove the  screws attaching
the door stop to the mounting frame and set aside.
. After installing the mounting frame and front on the fireplace, re-
install the  screws.
Figure 48.1
Installing Mounting Bracket on Fireplace
1. Use a Phillips Head screwdriver and attach the mounting frame
to the face of the fireplace with 5 screws on the top and bottom
and 4 on each side. Figure 48.2.
. The front is attached to the mounting frame via the hinges.
. All 4 fronts are mounted the same way.
Front
Figure 48.2
Page 48
Installing Front onto Mounting Frame
Mounting
Frame
7051-158
Hinge on Fireplace
Hinge on Front
Start with Bottom Hinge
Alignment and then Top
Figure 48.3
Hinges Aligned
Figure 48.4
Push Up on
Spring Loaded
Hinge Pin
Figure 48.5
Push Locking Tab into
Place to Hold Hinge Pin
Locking Tab
Figure 48.6
R
April 9, 2009