Wall Control Error Messages - Quadra-Fire Edge60 Owner's Manual

R
R R
B. Wall Control Error Codes
Error Message
SNAP DISC TRIPPED
AUGER JAMMED
MISSED IGNITION
MIN FIREPOT TEMP
MAX DROP TUBE TEMP
CHECK ASHPAN
SCREEN GOES BLANK
April 9, 2009
Possible Cause
Overheat sensor (snap disc) has tripped
Convection blower may need cleaning
Auger jammed, feed motor bad
Out of fuel or fuel has clumped together to form
a dam in hopper
Out of fuel
Wrong fuel table setting
Flame height set too high
Components may need cleaning
Auto-clean jammed
Static discharge or nearby lightening or Electric
Fast Transients at the input mains
Hopper lid not closed all the way.
Firebox door is not latched properly
Fireplace may not be rolled in completely
Out of fuel
Turn power off to appliance and manually reset snap
disc then turn back on. If that doesn't work, call your
dealer.
Clean convection blower if needed.
Use clean-out tool to clear jam.
Empty hopper and look for foreign objects and
remove
Turn the power switch OFF and then back ON to
clear error code
Break up pellets that have clumped together
Refill hopper if fuel level is low
Refill hopper
Add handful of pellets to firepot
Confirm setting matches burning fuel
Adjust flame height
Clean the firebox, heat exhanger, convection blower,
firepot and ash pan. If problem persists, call your
dealer.
Turn the power switch OFF and then back ON to
clear error code.
If ash pan is empty, check for a jam. Use the clean-
out tool and firmly push in the firepot floor holes and
flex spring and push toward home to release jam. If
problem persists, call your dealer.
Wait 5 seconds and press any key. If the screen
does not come back on, call your dealer.
Close the lid. If that didn't work the switch is out,
call your dealer.
Check the latch, if OK the door switch may be out,
call your dealer.
If fireplace is completely rolled in, interlock switch
may be out, call your dealer.
Check fuel level, if OK the switch may be out, call
your dealer.
7051-158
EDGE 60 Pellet Fireplace
Corrective Action
Page 1