Junction Box And Wiring Diagram; Connecting Wall Control To Fireplace - Quadra-Fire Edge60 Owner's Manual

EDGE 60 Pellet Fireplace
C. Junction Box & Wiring Diagram
Caution! The fireplace should be securely attached to the
floor prior to making final electrical connections.
Shock Hazard
• A grounded metal outlet power supply is
required for all installations.
• Provides a positive ground path to earth for
outer can of the fireplace.
• Protects against possible electrical shock.
1. Disconnect power supply providing power to the outlet
box you intend to use.
. The power supply cord is inside a 7-1/ foot (9cm)
long /8 inch (9.5mm) flexible conduit cable located and
attached to the left side of the outer can. Figure 34.1.
The cable comes with an insulated snap-in connection.
. Locate the metal outlet box within 7-1/ feet (18cm) of
the fireplace. (Note: Metal outlet box not supplied).
4. Feed the power cord into the 1/ inch (1.7mm) standard
knockout of the outlet box and then press the connection
onto the metal outlet box.
5. The power supply cord has black, white and green wires
to connect to the outlet box.
Black wire: Connects to 10V AC 15-0 amp circuit
White wire: Connects to neutral wire
Green wire: Connects to ground wire and outlet box
6. Ensure the  green grounding wires are securely attached
to the grounding screw. Figure 34.2.
Power Supply Cord inside 7.5 ft
(229cm) Flexible Cable
Thermostat Wall Control Wire
Figure 34.1 - Power Supply Cord
and Wall Control Wire
Page 4
WARNING
White
Wires
Both Green Grounding Wires
Attach to Grounding Screw
Figure 34.2 - Metal Outlet Box
D. Connecting Wall Control To Fireplace
1. There is a 5 screw terminal connection bar that is located
in the lower left side of the fireplace above the slide rails.
Figure 34.3.
. Route the 5 foot (76cm) long white wall control wire
that is supplied in the component pack through the rubber
grommet in the left side of the fireplace outer can. Figure
34.1
. The center  screws are for the thermostat wall control
wires and the  outer screws are mounting screws and
should not have wires attached to them.
The thermostat wires are color coded. The green wire
is on the top, the white in the middle and the red on the
bottom.
5. Attach the wall control wire to the thermostat wall control
Follow the directions on page 5. Do not pinch the con-
trol wires with any staples between the fireplace and wall
control. Figure 35.1 on page 35.
6. Bend back the  red spade connectors towards inside of
outer can and away from the fireplace. Wires should not
be in the way when the fireplace is rolled out on the rail
system.
Black
Wires
Grounding
Screw
7051-158
Matching
Green
Color Dots
White
Red
Fireplace Left Lower Front
Figure 34.3 - Terminal Connec-
tion Bar
April 9, 2009
R