Audible Message Alert; Outgoing Messages - BT Freelance XC 500 User Manual

Freelance XC 500 ~ 1st Edition ~ 6th March '03 ~ 5165
To change the answer
delay setting
Press and hold the SKIP
button on the base unit
until the current setting is
announced, then release.
Press and release the
SKIP
through the settings, with
each press the options
will be announced and will
also be shown on the
base unit display, i.e 8, 9,
Time Saver, (see page 50)
2, 3, 4, 5, 6, 7.
When you hear the setting
you want, do not press the
SKIP
a short delay your chosen
setting will be announced.
To check the answer
delay setting at the
base station
Press and release the
SKIP
The current setting will be
announced and also shown
on the base unit display.
35
button to move
button again. After
button.

Audible Message alert

When new messages have been
received, your Freelance XC 500
will beep every 10 seconds (when
audible message is switched ON).
The volume of the beep is at the
volume you have set for the
loudspeaker. The default setting
is OFF.
To switch audible
message alert ON or OFF
When the answering
machine is set to ON and
in the idle mode:
Press and hold the
SKIP button on the base
unit to change the setting.
The prompt will announce
"Message alert on/off" as
appropriate.

Outgoing messages

The outgoing message is the
message a caller first hears when
the answering machine picks up
their call. Your Freelance XC 500
comes with 2 pre-recorded
outgoing messages to choose from
as follows: