Insert The Batteries - BT Freelance XC 500 User Manual

Freelance XC 500 ~ 1st Edition ~ 6th March '03 ~ 5165
Warning
Under no circumstances should
non-rechargeable batteries be
used. Only use the approved
batteries. Using unapproved
batteries will invalidate your
guarantee and may damage the
telephone.
3

Insert the batteries

Insert the two batteries
supplied, as indicated
on the markings inside
the battery compartment
and slide the battery
compartment shut.
The handset display will
show HANDSET 1. This
means one handset is
registered to the base.
(If you have purchased the
Freelance XC 500 Twin the
additional handset will show
HANDSET 2.)
13
Charge the handset
4
batteries for at least
16 hours
Before you use your
Freelance XC 500 for the
first time it is important to
have the handset batteries
fully charged. Place the
handset on the base.
You will hear a long beep.
The red charging light
on the base will come on
and the battery. Leave
the handset to charge
continuously for at least 16
hours to reach full charge.
Note
The charging light will remain
lit even when the batteries are
fully charged.
Battery levels
Battery low warning
If the handset battery symbol is
empty, you will hear a warning
beep every 10 seconds, you will
need to recharge your handset
before you can use it.