Using the Operator Panel
Default Font
2-38
3
Press [OK] ([ENTER]). A blinking question
mark (?) appears.
4
Select KPDL or KPDL (AUTO) using
.
5
Press [OK] ([ENTER]).
6
Press
. Press
Errs (errors) appears.
7
Press [OK] ([ENTER]). A blinking question mark (?) appears.
8
Select On using
([ENTER]).
9
Press [MENU]. The display returns to Ready.
You can select the default font for the current interface. The default font
can be one of the internal fonts or a font that is downloaded to the printer
memory or stored on memory card or hard disk.
In this menu, you can also set the type and pitch for Courier and Letter
Gothic; as well as to print a font list.
1
Press [MENU].
2
Press
or
repeatedly until Font >
appears.
3
Press
. Press
Select > appears.
4
To select an internal font, make sure that
Internal is displayed and press
display changes. If Internal is not
displayed, press [OK] ([ENTER]), then
press
or
until it appears.
or
or
until >Print KPDL
or
. Press [OK]
or
until >Font
. The
ADVANCED OPERATION GUIDE
Emulation
?PCL 6
Emulation
?KPDL
>Print KPDL Errs
Off
>Print KPDL Errs
? Off
Font
>
>Font Select
>
Internal
>> I000