Oce PP18C Operation Manual page 46

Using the Operator Panel
Using Proof-and-Hold
2-20
5 Press [OK] ([ENTER]). A blinking question
mark (?) appears before the user name.
6 Press or
name, Arlen, in this example.
7 Press [OK] ([ENTER]). The job name
entered in the printer driver (Report, in this
example) appear with a blinking question
mark (?) before the letters.
8
Press or
9 Press [OK] ([ENTER]). The number of
copies to be printed can be set. To increase
the copy count, press
copy count, press
10
Press [OK] ([ENTER]) to finalize the copy count. The printer prints the
specified number of copies for the job.
Deleting a Quick Copy Job
1 Follow steps 1 through 8 in the above section to let the title of the job to be
deleted displayed.
2
When the title of the job to be deleted is
displayed, e.g. Report, press [OK]
([ENTER]). The cursor below the copy
count starts to blink.
3 Press repeatedly until Delete appears
below the title.
4 Press [OK] ([ENTER]). The stored quick copy job is deleted.
When you print multiple copies, this mode first prints one copy so that you
can proof it before continuing to print the remaining copies. Since you can
proof the printouts before printing the remaining copies, wastage of paper
can be reduced.
The printer prints one copy and, at the same time, saves the print job on
the hard disk/RAM disk. You can also change the number of copies when
resuming printing from the operator panel.
When the printer is turned off, all stored jobs will be deleted.
to display the desired user
to scroll to the desired job title.
; to decrease the
.
>Quick Copy
?Harold
>Quick Copy
?Arlen
>Arlen
?Report
>Report
Copies
>Report
Copies
>Report
Delete
ADVANCED OPERATION GUIDE
001
001