Oce PP18C Operation Manual page 47

Printing a Private Print/Stored Job
ADVANCED OPERATION GUIDE
Printing Remaining Copies of a Proof and Hold Job
Printing a Proof-and-Hold job on the operator panel is similar to printing a
quick copy job. See Printing Additional Copies using Quick Copy on page
2-19.
In private printing, you can specify that a job is not printed until you release
the job from the operator panel. When sending the job from the application
software, specify a 4-digit access code in the printer driver. The job is
released for printing by entering the access code on the operator panel
ensuring confidentiality of the print job.
In the stored job mode, access codes are not mandatory, but can be set
on the printer driver if printing with PIN security is required. Then, the
access code must be entered on the operator panel to print a stored job.
Print data will be stored in the hard disk after printing. See KX Printer
Drivers Operation Guide for the driver settings.
Releasing a Private/Stored Job
1 Press [MENU].
2
Press or
appears.
3 Press .
4
Press or
Stored appears. The name entered in the
printer driver (Harold, in this example) also
appears.
5 Press [OK] ([ENTER]). A blinking question
mark (?) appears before the user name.
6 Press or
name (Arlen, in this example).
7 Press [OK] ([ENTER]). The user name and
the job name (Agenda, in this example)
entered in the printer driver appear with a
blinking question mark (?).
8 Press or
repeatedly until e-MPS >
repeatedly until >Private/
to display the desired user
to display the desired job title.
Using the Operator Panel
e-MPS >
>Private/Stored
Harold
>Private/Stored
?Harold
>Private/Stored
?Arlen
>Arlen
?Agenda
2-21