Oce PP18C Operation Manual page 48

Using the Operator Panel
2-22
9 Press [OK] ([ENTER]). The ID input line
appears. Enter the four-digit access code
entered in the printer driver and press [OK]
([ENTER]).
To enter the ID, press
changed and then enter the correct number by pressing
10 You can set the number of copies to be
printed. To increase the copy count, press
; to decrease the copy count, press
11 Press [OK] ([ENTER]) to finalize the copy count. The printer prints the
specified number of copies for the job.
Deleting a Private/Stored Job
You can individually delete stored jobs by performing the following
procedure. Jobs saved using Private Print will be automatically deleted if
you turn the power off after printing, but jobs saved using Stored Job will
not be deleted automatically.
1
Follow steps 1 through 8 in the above section.
2
When the title of the job to be printed is
displayed (Agenda, in this example), press
[OK] ([ENTER]). Enter the four-digit access
code entered in the printer driver and press
[OK] ([ENTER]).
3
Press repeatedly until Delete appears
for the number of copies.
4
Press [OK] ([ENTER]). The private job is deleted from the hard disk.
Printing a Code Job
To print a code job, ensure that the KM-NET for Clients is installed on the
computer. The KM-NET for Clients is provided on the Software Library
CD-ROM.
For details, refer to the KM-NET for Clients Operation Guide.
>Agenda
or to move the cursor to the number to be
>Agenda
.
>Agenda
>Agenda
ADVANCED OPERATION GUIDE
ID 0000
or .
Copies 001
Copies 001
Delete