License Plate Lamp; Replacement Bulbs; Electrical System; Overload - Chevrolet 2010 Camaro Owner's Manual

License Plate Lamp

To replace one of these bulbs:
1. Unclip the license plate lamp
from the facia opening.
2. Pull the license plate lamp down
through the facia opening.
3. Turn the bulb socket
counterclockwise and pull the
bulb straight out of the lamp
socket.
4. Install the new bulb.
5. Push the bulb straight into the
socket and turn clockwise to
reinstall.
6. Reinstall the license plate lamp
by lifting it through the facia
opening until the clip is in place.

Replacement Bulbs

Exterior Lamp
Number
Daytime Running
Lamp (Up-level
vehicles)
Fog Lamp
Front Park and Turn
3457NAK
Signal Lamp
Halogen Headlamp
License Plate Lamp
Rear Turn Signal
and Taillamps
For replacement bulbs not listed
here, contact your dealer.
I n f o r ma t i o n P r o v i d e d b y :
Vehicle Care

Electrical System

Electrical System

Overload

The vehicle has fuses and circuit
breakers to protect against an
electrical system overload.
When the current electrical load is
Bulb
too heavy, the circuit breaker opens
and closes, protecting the circuit
until the current load returns to
P13W
normal or the problem is fixed.
This greatly reduces the chance
of circuit overload and fire caused
PS24W
by electrical problems.
Fuses and circuit breakers protect
the following in the vehicle:
H13
Headlamp Wiring
W5W
Windshield Wiper Motor
3157K
Power Windows and other
Power Accessories
9-41