Chevrolet 2010 Camaro Owner's Manual page 169

Using the Digit Dial Command
1. Press . The system
responds Ready followed by
a tone.
2. Say Digit Dial . The system
responds Digit dial using
<phone name>, please say the
first digit to dial followed by
a tone.
3. Say the digits to be dialed one
at a time. The system repeats
back the digit it heard followed
by a tone.
4. Continue entering digits until the
number to be dialed is complete.
After the whole number has
been entered, say Dial . The
system responds OK, Dialing
and dials the number.
If an unwanted number is
recognized by the system,
say Clear at any time to
clear the last number.
To hear all of the numbers
recognized by the system,
say Verify at any time.
Using the Call Command
1. Press . The system
responds Ready followed
by a tone.
2. Say Call . The system responds
Call using <phone name>.
Please say the name tag
followed by a tone.
3. Say the name tag of the person
to call.
If the system recognizes
the name tag it responds
OK, calling, <name tag>
and dials the number.
If the system does not
recognize the name tag,
it confirms the name tag
followed by a tone. If the
name tag is correct, say
Yes . The system responds
OK, calling, <name tag>
and dials the number. If the
name tag is not correct, say
No . The system will ask
for the name tag again.
I n f o r ma t i o n P r o v i d e d b y :
Infotainment System
Once connected, the person called
will be heard through the audio
speakers.
Using the Re dial Command
1. Press . The system
responds Ready followed by
a tone.
2. After the tone, say Re dial .
The system responds Re dial
using <phone name> and dials
the last number called from the
connected Bluetooth phone.
Once connected, the person called
will be heard through the audio
speakers.
Receiving a Call
When an incoming call is received,
the audio system mutes and a ring
tone is heard in the vehicle.
Press to answer the call.
Press to ignore a call.
6-31