Programming; Universal Remote System; Operation; Universal Remote System Operation - Chevrolet 2010 Camaro Owner's Manual

To program the remaining two
Universal Home Remote buttons,
begin with Step 1 of Programming
the Universal Home Remote
System .
Gate Operator and Canadian

Programming

If you have questions or need
help programming the Universal
Home Remote System,
call 1 800 355 3515 or go
to www.homelink.com.
Canadian radio-frequency laws
require transmitter signals to time
out or quit after several seconds
of transmission. This may not be
long enough for Universal Home
Remote to pick up the signal during
programming. Similarly, some U.S.
gate operators are manufactured to
time out in the same manner.
If you live in Canada, or you are
having difficulty programming a gate
operator or garage door opener by
using the Programming Universal
Home Remote procedures,
regardless of where you live,
replace Step 2 under Programming
Universal Home Remote with the
following:
2. Continue to press and hold
the Universal Home Remote
button while you press and release
every two seconds (cycle) the
hand-held transmitter button
until the frequency signal has
been successfully accepted
by the Universal Home Remote.
The Universal Home Remote
indicator light will flash slowly at
first and then rapidly. Proceed
with Step 3 under Programming
Universal Home Remote to
complete.
I n f o r ma t i o n P r o v i d e d b y :
Instruments and Controls

Universal Remote System

Operation

Using Universal Home Remote
Press and hold the appropriate
Universal Home Remote button
for at least half of a second.
The indicator light will come on
while the signal is being transmitted.
Erasing Universal Home
Remote Buttons
All programmed buttons should be
erased when the vehicle is sold or
the lease ends.
To erase all programmed buttons on
the Universal Home Remote device:
1. Press and hold down the
two outside buttons until the
indicator light begins to flash,
after 10 seconds.
2. Release both buttons.
4-47