P5SJ-A User's Manual
4: Reference Information – 4.32
Doze Mode
This sets the period of system inactivity after which the sys-
tem goes into Doze mode, the most limited power saving state.
The settings range from 1 minute to 1 hour and can be set manu-
ally when power management is in User Define mode. The de-
fault setting is Disabled. When the system goes into power sav-
ing mode, power management will skip to the next mode in the
sequence if this is disabled.
Standby Mode
This sets the period of system inactivity after which the sys-
tem goes into Standby mode, the intermediate power saving state.
The settings range from 1 minute to 1 hour and can be set manu-
ally when power management is in User Define mode. The de-
fault setting is Disabled. When the system goes into power sav-
ing mode, power management will skip to the next mode in the
sequence if this is disabled.
Suspend Mode
This sets the period of system inactivity after which the sys-
tem goes into Suspend mode, the maximum power saving state.
The settings range from 1 minute to 1 hour and can be set manu-
ally when power management is in User Define mode. The de-
fault setting is Disabled. When the system goes into power sav-
ing mode, power management will skip to the next mode in the
sequence if this is disabled.
HDD Power Down
This shuts down IDE hard disks that support a power saving
mode after a specified time period. The settings range from 1 to
15 minutes and can be set manually when power management is
in User Define mode. HDD Power Down does not affect SCSI
hard disks. The default setting is Disabled.