Optional Hardware - ECS P5SJ-A User Manual

P5SJ-A User's Manual
2: Using Your Mainboard – 2.8

Optional Hardware

There two feature connectors on the mainboard for optional
ports. These require optional external port hardware.
USB Ports
The USB1 connector on the mainboard supports two Univer-
sal Serial Bus ports. An optional external port bracket attaches to
the onboard connector via an attached cable.
With the optional port bracket installed you can attach USB
devices to the external ports. If the USB ports are installed, the
USB Controller line in the Integrated Peripherals section of the
CMOS Setup utility must be set to 'Enabled'. USB ports may
also require Operating System support for USB devices.
IR Port
The onboard IR connector supports an Infra-Red port module
that enables wireless communication between the computer and
other computers and devices with infrared capability.
The port module is an optional component. If it is installed,
you must set the UART 2 line in the Integrated Peripherals sec-
tion of the CMOS Setup utility to the appropriate IR mode used
by the module.