Ethernet Configuration Menu - Cisco 7942G Administration Manual

Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Table 4-13 Media Configuration Menu Options (continued)
Option Description
Enterprise Advertise Enables/disables Cisco Unified IP Phones to
G.722 Codec advertise the G.722 codec to Cisco Unified
Communications Manager. If enabled (default),
and if each endpoint in the attempted call supports
G.722 in its capabilities set, Cisco Unified
Communications Manager will choose G.722
for the call.
Note
Device Advertise Allows you to override the Enterprise Advertise
G.722 Codec G.722 Codec on a per-phone basis.
The default is "Use System Default," which
means the value configured for the Enterprise
Advertise G.722 Codec parameter gets used.

Ethernet Configuration Menu

The Ethernet Configuration menu includes the options that are described in
Table 4-14 Ethernet Configuration Menu Option
Option Description
Span to PC Port Indicates whether the phone will forward packets
transmitted and received on the network port to the
access port.
Enable this option if an application that requires
monitoring of the phone's traffic is being run on
the access port. These applications include
monitoring and recording applications (common
in call center environments) and network packet
capture tools that are used for diagnostic purposes.
Forwarding Delay Indicates whether the internal switch begins
forwarding packets between the PC port and
switched port on the phone when the phone
becomes active.
•
•
Default is disabled.
Cisco Unified IP Phone 7962G and 7942G Administration Guide for Cisco Unified Communications Manager 6.1(3)
OL-17679-01
When a phone is registered with a Cisco
Unified Communications Manager that
does not support this setting, the default
is "Disabled."
When forwarding delay is set to disabled, the
internal switch begins forwarding packets
immediately.
When forwarding delay is set to enabled, the
internal switch waits eight seconds before
forwarding packets between the PC port and
the switch port.
To Change
From Cisco Unified Communications Manager
Administration, choose System > Enterprise
Parameters.
From Cisco Unified Communications Manager
Administration, choose Device > Phone.
Table
To Change
From Cisco Unified Communications Manager
Administration, choose Device > Phone > Phone
Configuration.
From Cisco Unified Communications Manager
Administration, choose Device > Phone > Phone
Configuration.
Device Configuration Menu
4-14.
4-21