Cisco 7942G Administration Manual page 84

Device Configuration Menu
Table 4-13 Media Configuration Menu Options (continued)
Option Description
Recording Tone Local Indicates the loudness setting for the beep tone
Volume that is received by the party whose phone has the
Recording Tone option enabled.
This setting applies for each listening device
(handset, speakerphone, headset).
Range: 0 percent (no tone) to 100 percent (same
level as current volume setting on the phone).
Default: 100
See also: Recording Tone
Recording Tone Indicates the loudness setting for the beep tone
Remote Volume that the remote party receives. The remote party
is the party who is on a call with the party whose
phone has the Recording Tone option enabled.
Range: 0 percent to 100 percent. (0 percent is
-66 dBM and 100 percent is -3 dBM.)
Default: 84 percent (-10dBM)
See also: Recording Tone
Recording Tone Indicates the length of time in milliseconds for
Duration which the beep tone plays.
If the value you configure here is less than one
third the interval, then this value overrides the
default provided by the Network Locale.
Range: 0 to 3000
Note
See also: Recording Tone
Wideband Headset Indicates whether wideband is enabled or
disabled for the headset.
Default: Disabled
Cisco Unified IP Phone 7962G and 7942G Administration Guide for Cisco Unified Communications Manager 6.1(3)
4-20
For some Network Locales that use a
complex cadence, this setting applies
only to the first beep tone.
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
To Change
From Cisco Unified Communications Manager
Administration, choose Device > Phone > Phone
Configuration.
From Cisco Unified Communications Manager
Administration, choose Device > Phone > Phone
Configuration.
From Cisco Unified Communications Manager
Administration, choose Device > Phone > Phone
Configuration.
If Wideband Headset UI Control is enabled,
•
you or the user can use the phone and choose
> User Preferences > Audio
Preferences > Wideband Headset.
If Wideband Headset UI Control is disabled,
•
from Cisco Unified Communications
Manager Administration, choose Device >
Phone > Phone Configuration to set this
value.
If you allowed this option to be user
Note
controllable (in the Wideband Headset UI
Control option), the user-configured value
takes precedence.
OL-17679-01