Cisco 7942G Administration Manual page 74

Network Configuration Menu
Table 4-3 IPv4 Configuration Menu Options (continued)
Option
TFTP Server 1
TFTP Server 2
BOOTP Server
Cisco Unified IP Phone 7962G and 7942G Administration Guide for Cisco Unified Communications Manager 6.1(3)
4-10
Description
Primary Trivial File Transfer Protocol (TFTP) server
used by the phone. If you are not using DHCP in your
network and you want to change this server, you must
use the TFTP Server 1 option.
If you set the Alternate TFTP option to yes, you must
enter a non-zero value for the TFTP Server 1 option.
If neither the primary TFTP server nor the backup
TFTP server is listed in the CTL file on the phone, you
must unlock the CTL file before you can save changes
to the TFTP Server 1 option. In this case, the phone
will delete the CTL file when you save changes to the
TFTP Server 1 option. A new CTL file will be
downloaded from the new TFTP Server 1 address.
For information about the CTL file, refer to Cisco
Unified Communications Manager Security Guide.
For information about unlocking the CTL file, see the
"Security Configuration Menu" section on page
Optional backup TFTP server that the phone uses if
the primary TFTP server is unavailable.
If neither the primary TFTP server nor the backup
TFTP server is listed in the CTL file on the phone, you
must unlock the CTL file before you can save changes
to the TFTP Server 2 option. In this case, the phone
will delete the CTL file when you save changes to the
TFTP Server 2 option. A new CTL file will be
downloaded from the new TFTP Server 2 address.
For information about the CTL file, refer to Cisco
Unified Communications Manager Security Guide.
For information about unlocking the CTL file, see to
the "Security Configuration Menu" section on
page 4-27.
Indicates whether the phone obtains its configuration
from a Bootstrap Protocol (BootP) server instead of
from a DHCP server.
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
To Change
Unlock the CTL file if necessary (for
1.
example, if you are changing the
administrative domain of the phone).
2. If DHCP is enabled, set the Alternate
TFTP option to Yes.
3. Scroll to the TFTP Server 1 option,
press the Edit softkey, and then enter
a new TFTP server IP address.
Press the Validate softkey, and then
4.
press the Save softkey.
If you forgot to unlock the CTL
Note
file, you can change the TFTP
Server 1 address in the CTL file,
then erase the CTL file by
pressing the Erase softkey from
the Security Configuration menu.
4-27.
A new CTL file will be
downloaded from the new TFTP
Server 1 address.
Unlock the CTL file, if necessary
1.
(for example, if you are changing the
administrative domain of the phone).
2. Unlock network configuration
options.
3. Enter an IP address for the TFTP
Server 1 option.
Scroll to the TFTP Server 2 option,
4.
press the Edit softkey, and then enter
a new backup TFTP server IP
address.
Press the Validate softkey, and then
5.
press the Save softkey.
If you forgot to unlock the CTL
Note
file, you can change the TFTP
Server 2 address in the CTL file,
then erase the CTL file by
pressing the Erase softkey from
the Security Configuration menu.
A new CTL file will be
downloaded from the new TFTP
Server 2 address.
Display only—Cannot configure.
OL-17679-01