Table of Contents
Advertisement
Power up the System (for AC unit)
Once you have all cables connected properly, you are ready to turn on the system as follows:
1. Verify that the on/off switch is in the off position.
2. Plug in the power cord to a grounded AC outlet.
3. You may also provide ground using the supplementary Earth Ground post (see Prevent Electrostatic Dis-
charge Damage).
4. Locate the on/off switch on the front of the chassis (For Tenor CMS 14 slot) or the rear of the chassis (for
CMS 240 and CMS960), click the switch to On.
The chassis will power up and the LEDs will flash and turn off. For information about the LEDs, see Chapter
8: Diagnostics/Maintenance.
Once the chassis is powered up and has completed the boot up process, you are ready to assign an IP address.
See section Assign IP Address.
P/N 480-0005-00-15
Chapter 3: Installation
3-17
Advertisement
Table of Contents
