System Maintenance Switch (Sw2); Hot-Plug Redundant Power Supply/Pci Switch (Sw1) Settings - HP DL360 Maintenance And Service Manual

LEDs, Switches, and Jumpers

System Maintenance Switch (SW2)

The system maintenance switch (SW2) is an eight-position switch used for system
maintenance. Refer to the labels attached to the inside of the server access panel for the
proper system configuration switch settings. The following table shows the shipping
configuration of SW2.
Table 5-4: System Maintenance Switch (SW2) Settings
Position
S1
S2
S3
S4
S5
S6
S7
S8
Note: "On" activates the funct ion.

Hot-Plug Redundant Power Supply/PCI Switch (SW1) Settings

The hot-plug redundant power supply/PCI switch (SW1) is a four-position switch used for
system maintenance. Refer to the labels attached to the inside of the server access panel for
the proper switch settings. Table 5-5 shows the shipping configuration of SW1.
Table 5-5: Hot-Plug Redundant Power Supply/PCI Install Switch (SW1) Settings
Position
S1
S2
S3
S4
5-6
Function Default
iLO service Off
override
Configuration lock Off
Reserved On
Floppy disable Off
Password override Off
Reset configuration Off
Reserved Off
Reserved Off
Function
Reserved
Reserved
Reserved
Identify PCI slot or redundant
power supply support
HP ProLiant DL360 Generation 3 Server Maintenance and Service Guide
Description
Off = No function
On = Override iLO security enabled
Off = System configuration can be changed
On = System configuration is locked
Reserved
Off = Disable floppy boot
On = Override RBSU setting and enable floppy boot
Off = Honor RBSU password setting
On = Override RBSU setting and override password
prompts
Off = No function
On = ROM reads system configuration as invalid,
reset configuration
Reserved
Reserved
Default Description
Off Reserved
On Reserved
Off Reserved
Off Off = Normal (PCI slot 2 supported)
On = Hot-plug redundant power supply
installed