Switches - HP DL360 Maintenance And Service Manual

Switches

The system board contains three switchbanks that may need to be modified to set
configuration or to trigger special functions. These switches can cause problems if they are
not correctly set.
When adding or removing a component or changing a security feature, the server must be
reconfigured to recognize these changes. If the system configuration is incorrect, the server
may not work properly, and you may receive error messages on the screen.
IMPORTANT: Reserved switches are provided for use by HP authorized service providers
only and should not be changed from the indicated default settings.
Refer to Figure 5-3 and Table 5-3 for locations on the system board of the switches.
The following subsections provide reference information about setting the system board
switches and jumpers, which is part of the reconfiguration process, along with running the
ROM-Based Setup Utility (RBSU).
HP ProLiant DL360 Generation 3 Server Maintenance and Service Guide
LEDs, Switches, and Jumpers
5-5