Hard Drive Blank; Hot-Plug U320 Scsi Hard Drives - HP DL360 Maintenance And Service Manual

Hard Drive Blank

To remove a hard drive blank:
1. Press the release button (1).
2. Pull the blank out of the drive bay (2).
Figure 2-8: Removing a hard drive blank
To replace the hard drive blank, slide the blank into the bay until it locks into place.

Hot-Plug U320 SCSI Hard Drives

To assess a hard drive's status, you must observe and understand the hot-plug hard drive
status LEDs. For a detailed explanation of hard drive status LEDs, refer to the HP ProLiant
DL360 Generation 3 Server Setup and Installation Guide.
HP ProLiant DL360 Generation 3 Server Maintenance and Service Guide
CAUTION: Do not operate the server without a hard drive or a hard drive blank installed.
Failure to install a hard drive or a hard drive blank can lead to improper cooling and may
damage the system.
WARNING: Read "Hot-plug Hard Dr ive Replacement Guidelines" in the HP ProLiant
Servers Troubleshooting Guide before removing a hard drive.
CAUTION: Do not operate the server without a hard drive or a hard drive blank installed.
Failure to install a hard drive or a hard drive blank can lead to improper cooling and may
damage the system.
Removal and Replacement Procedures
2-11