Table of Contents
Advertisement
■ MMSI code programming
The 9 digit MMSI (Maritime Mobile Service Identity: DSC self
ID) code can be programmed at power ON.
This initial code setting can be performed only once.
After being set, it can be changed by only your dealer
or distributor.
q First, turn OFF the power. Then, while holding down
[MENU], push [POWER] to turn ON the power to enter the
MMSI code programming mode.
w After the display appears, release [MENU].
e Enter "MMSI Check" in the DSC Set up menu.
➪
DSC Menu
Set up
(Push [MENU])
(Rotate [DIAL], then push [DIAL•ENTER].)
r Rotate [DIAL] to input the specific 9 digit MMSI code.
• Push [16•9] to move the cursor forward, or [CH/WX•DUAL•U/
I/C] to move it backward.
• Push [CLR] to cancel and return to the Set up menu.
--DSC Menu--
MMSI Check
_________
<CLR˘Exit / ENT˘OK>
➪
MMSI Check
DSC OPERATION
t After inputting the 9 digit code, push [DIAL•ENTER] to
program.
• Returns to the set up menu.
y Push [CLR], or rotate [DIAL] to select "Exit" then push
[DIAL•ENTER], to return to the DSC menu.
• Push [DIAL•ENTER] again to return to the normal operating
mode.
The programmed MMSI code can be checked in the DSC Set
mode. (p. 45)
6
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
15
Advertisement
Table of Contents
