Motion Recording - Lorex LIVE LW2710 Series Instruction Manual

Motion recording

Use Motion Recording to have the
system only record when motion is
detected by one of the cameras. The
camera that appears on-screen is the
only camera that is recording.The PIR
sensor allows the camera to detect
movement. The maximum range on the
PIR sensor is 21 feet (6.5 meters).
A camera detects movement, and triggers the system to
record.
To enable Motion Recording:
Prerequisite: Insert an empty SD card
into the LCD receiver.
1 During live view, press the Motion button
on the remote control.
• "AUTO REC" will light up on the LCD
receiver.
2 Perform one of the following:
• Enable Quad Mode (recommended):
Press the Quad button on the remote.
When motion is detected, the system will
display the triggered camera on-screen.
When motion recording is complete, the
view will return to Quad Mode.
• Enable Auto Sequence Viewing Mode:
Press the CHANNEL-A button on the
remote. When motion is detected, the
system will display the triggered camera
on-screen. When motion recording is over,
Auto Sequence Viewing Mode will continue
as normal.
• Change channels manually: Press the
CHANNEL-M button on the wireless
receiver or remote control to select a
channel.
ATTENTION
If you manually select a channel while
the system is in Motion Recording
Mode, motion recording will ONLY
apply to the selected channel. For
example, with Motion Recording
enabled, you manually select channel
3; if motion were to occur in view of
camera 1, the system would NOT
RECORD video from channel 1.
3 Press the Motion button on the remote
again to stop Motion Recording. "AUTO
REC" will turn off on the receiver.
• The "REC" indicator will only appear when
motion is detected by one of the cameras
on-screen.
• By default, the system is set to record for
15 seconds after the triggered motion
event. For details on adjusting the motion
recording time, see "Record Time" on
page 24.
Recording Tip:
If you are using more than one camera,
it is highly recommended to use Quad
Mode with Motion Recording. Quad
Mode allows you to see all four cameras
at once. When motion is detected, the
triggered camera will appear
on-screen. After motion recording is
complete, the receiver will return to
Quad Mode.
Recording
19