Olympus FE-320 Quick Start Manual page 23

150
Changing the ISO sensitivity
AUTO Sensitivity is automatically adjusted according to the conditions of the
subject.
64/100/200/4001 A low value lowers the sensitivity for daylight shooting of clear, sharp
800/1600/3200 pictures. The higher the value, the better the camera's light sensitivity and
ability to shoot with a fast shutter speed and in low light conditions.
However, high sensitivity introduces noise into the resulting picture, which
may give it a grainy appearance.
• When [3200] is selected, [IMAGE SIZE] is limited to IIlM)] or lower.
FINE ZOOM
Zooming in on your subject without reducing image quality
OFF ION
Combines optical zoom and image capture to enable greater magnification (Max. 15x (FE-320/X-835/C-540)/
Max. 25x (FE-340/X-855/C-560)). There is no deterioration in the image quality since data conversion (by
increasing pixel resolution) is not performed.
• The available magnification varies depending on the [IMAGE SIZE] setting.
• The available [IMAGE SIZE] setting is []M)] or lower.
~
(still pictures)
Recording sound with still pictures
OFF
ION
PANORAMA
Creating a panoramic picture
Panorama shooting lets you create a panoramic picture, using the OLYMPUS Master software on the
provided CD-ROM. An Olympus xD-Picture Card is required for panorama shooting.
When activated [ON], the camera will record about 4 seconds of
audio after the picture is taken.
When recording, aim the camera microphone at the source of
the sound you want to record.
s:
CD
::J
C
o
""0
CD
tu
~
o
::J
en
Microphone
Connects pictures from bottom to top
b..:
The next picture is
connected at the top.
\l:
The next picture is
connected at the
bottom.
I
I
I
r
•
I
I
I
-
; -
t>:
The next picture is
connected at the
-~ ~-
right edge.
<1:
The next picture is
connected at the left
edge.
'-- '--
Connects pictures from left to right
Use the arrow pad to specify at which edge you want to connect the pictures; and then compose your shots
so that the edges of the pictures overlap. The part of the previous picture where it will be joined to the next
picture does not remain in the frame. You have to remember what the part in the frame looked like and take
the next picture so it overlaps.