Table of Contents
Advertisement
TABLE
1. Assemble the table (A) Fig. 7, to the base using the
two M6x1x35mm flat head screws (B) and T-nuts (C).
Insert the two screws (B) into the two holes (D) in table
(A). Place the two T-nuts (C) into the slots (E) provided in
the bottom of the base and tighten the two screws (B)
into the two T-nuts (C) securely.
2. The table (A) Fig. 7, can be moved in or out by
loosening the two screws (B), and re-positioning the
table, and then tightening screws (B).
FENCE AND HOLDDOWN
1. Locate handle assembly and remove screw (A) Fig. 8,
and spring (B) from handle (C). Sperate handle (C) from
stud (D).
2. Thread stud (D) Fig. 9, into hole on side of column,
as shown. Do not thread stud (D) all the way into hole at
this time.
3. Reassemble handle (C) Fig. 9, on stud (D) and re-
place screw (A) and spring (B).
4. Fig. 10 illustrates the handle assembly (C) attached to
the column.
E
A
C
D
B
D
8
E
Fig. 7
C
B
A
Fig. 8
D
C
B
A
Fig. 9
C
Fig. 10
Hide quick links:
Advertisement
Table of Contents
