Firmware Updates - Extron electronics SSP 7.1 User Manual

Firmware Updates

NOTE: Ensure that you are using the latest versions of the SSP 7.1 Setup and Control
Upgrade the SSP 7.1 firmware as follows:
1.
2.
3.
4.
5.
6.
7.
8.
Software and firmware. To update firmware, install the Extron Firmware Loader
on your PC. All three programs are available from the
To download software from the Extron Web site, click on the Download tab and
select either the Firmware or Software option in the left sidebar. Navigate to
the appropriate program and click Download. Follow the on-screen instructions
to install the program.
Turn off or disconnect all audio inputs before updating the firmware.
CAUTION: Updating the firmware while the unit is still accepting active audio inputs
may cause the firmware update to freeze.
Power on the SSP 7.1 and a computer.
Connect the computer to the SSP 7.1 through the rear panel RS-232 captive screw
connectors.
If necessary, install the Extron
Firmware Loader utility. This is on
the software disk provided or can be
downloaded from the Extron Web
site (www.extron.com).
From the same site, download the
firmware for the SSP 7.1.
To download the firmware for the SSP 7.1, click on the Download tab at the top of the
Extron home page and then click Firmware in the sidebar to the left.
Navigate to the firmware for the SSP 7.1 and click on Download.
In the dialog box, click Save.
NOTE: Make a note of the folder where you save the firmware.
Extron Web
SSP 7.1 • Setup and Control Software
site.
56