Running The Ssp 7.1 Setup And Control Software; "Connect To Device?" Dialog Box - Extron electronics SSP 7.1 User Manual

When the SSP 7.1 Control and Setup software is opened directly to Live mode, the current
configuration in the device is read from the SSP 7.1 unit, automatically overwriting the
settings in the software. When the program is closed, you are prompted to save any changes
that have been made during that session.
Figure 13.

Running the SSP 7.1 Setup and Control Software

"Connect to device?" Dialog Box

The computer must be connected to the SSP 7.1 using either the RS-232 captive screw
connectors on the rear panel or the Config port on the front panel.
To start the program, click on the desk-top icon or click on the Windows Start button and
select All Programs > Extron Electronics > SSP7.1 > SSP7.1. When the program launches, the
"Connect to device?" dialog box (shown below) opens.
To work offline in Emulate mode, check the Emulate/Work offline box. To connect directly
to the SSP 7.1, leave the box unchecked.
Modes", for a description of each mode.
If you choose to work directly with the SSP 7.1:
1.
2.
Figure 14.
Save changed configuration Box
The Device name (SSP 7.1) and Connection Method (RS-232) are already entered and no
other selections are available for these fields.
Select the correct Com Port and Baud Rate (default 38400).
"Connect to device?" Dialog Box — Live Mode
See the previous section, "Live and Emulate
SSP 7.1 • Setup and Control Software 24